The AT-VM95ML, features a Nude Microlinear diamond, not only the Microlinear stylus will permit to double the duration of your stylus. The performance of a line contact stylus, will minimize the “inner groove distortion” as well as providing extended frequency response and maximize resolution in the medium and high frequencies of the audio program material.
Every cartridge diamond stylus becomes worn after a period of play.
Around 500 hours for a conical stylus, 300 hours for an Elliptical stylus, 1000 hours for a Microlinear stylus, and 800 hours for a Shibata stylus.
Our VM95 Series dual moving magnet cartridges can be used almost forever by replacing the interchangeable stylus. It is no longer necessary to purchase a complete cartridge when your diamond is worn out, you can simply buy the matching replacement stylus, but also enjoy the experience of upgrading your cartridge with a different stylus.
The six models of VM95 Series cartridges all use the same electromagnetic engine-body, therefore each of the six replacement styli are perfectly compatible.
Microlinear profile diamond stylus offers high frequency response with less wear and distortion than elliptical or conventional linear contact styli.
VM95 Series cartridges features two M2.6 threaded inserts allowing the installation of the cartridge onto tonearm or removable headshell without the use of nuts.Each cartridge is provided with one pair of 8mm M2.6 screws, one pair of 11mm M2.6 screws and two plastic washers.
|Type||VM Stereo Dual Magnet|
|Frequency Response||20 - 25,000 Hz|
|Channel Separation||23 dB (1 kHz)|
|Output Channel Balance||1.5 dB (1 kHz)|
|Output Voltage||3.5 mV (@ 1 kHz, 5 cm/sec)|
|Vertical Tracking Angle||23°|
|Vertical Tracking Force Range||1.8 - 2.2g (standard 2.0 g)|
|Stylus Size||2.2 x 0.12 mil|
|Stylus Construction||Nude Square Shank|
|Coil Impedance||3.3 kΩ (1 kHz)|
|Coil Inductance||550 mH (1 kHz)|
|DC Resistance||485 Ω|
|Static Compliance||20 x 10 – 6 cm / dyne|
|Dynamic Compliance||10 x 10 – 6 cm / dyne (100 Hz)|
|Wire Used for Coil||T.P. Copper|
|Recommended Load Impedance||47,000 Ω|
|Recommended Load Capacitance||100-200 pF|
|Dimensions||17.2 x 18.9 x 28.3 ( H x W x D mm)|
|Accessories Included||Two 11 mm installation screws;
Two 8 mm installation screws;